Payments accepted by Bank Transfer, email me, I cannot take credit card
Ordering is easy.
Email firstname.lastname@example.org telling me what you want, I will reply giving you the total price and payment options. Mail Order minimum of £8.00 Insured p/p
Rear (Butt) Bags
These bags are used to support and steady the back of the rifle when shooting, particularly useful at long range. The bags are made of a high quality green corduroy material and filled with small plastic beads that are not affected by water, nor do the absorb it so your bag does not weigh a ton when wet, nor does it go hard.
The bag is used by placing under the butt of the rifle and adjusting the bipod until the sights are just slightly high of the target centre, when in the shooting position the left hand (for right handed shooters) can genially squeezing the bag until sights are pointing at the centre of the target. £20.00
Rear (Butt) Bags Rider
These bag Riders are used to give a support area to rifles that either have a small Picatinny rail at the back of the rifle or is going to have one retrofitted. The bag rider gives a longer area for the butt of the rifle sits on. The bags are made of an Aluminium Clamp to attach to the Picatinny rail and a Acetal rod, The overall length is 150mm approx. It should be noted that Acetal is a tough strong plastic but is not known for its smooth finish, it often feels and looks slightly matt and may have some surface scratches, the type of plastic was chosen for its durability rather than looks. £25.00
Fulcrum Extender Both models come with a "It works Guarantee" If you fit the extender to your rifle and any component bends or breaks on your rifle under fair wear and tear or plain doesn't work it will be replaced or your money refunded within one year of purchase. P/P is not included, nor is unfair wear and tear such as attaching it to a 50 cal or any bipod that can't slide flex under recoil, not heeding any warnings listed etc, in other words not using that rare commodity common sense.
What are the differences between the Fulcrum extender junior and Fulcrum extender Senior?
The Junior kit is a good choice when used on one rifle or rifles that have the same length from the rear mount to the end of the barrel, the senior is the best choice when used on several different length rifles.
The Junior is not easily adjustable for length as there is no telescopic mechanism the senior has a telescopic mechanism, (compensates for different rifles)
The rifle tilt due to uneven ground is a function of the bipod attached not the Junior extender . The senior can rotate around the tube clamping so can be used with a fixed bipod without a swivel head.
The bipod on the junior is attached to the bottom of the tube so adds to the overall height of the rifle by 5cm rather than around 1cm for the senior which attaches to the top of the tube.
The Junior tube is 3cm for its entire length rather than 3.5cm and 3 cm on the senior.
The Junior comes with a clamp on 6 slot Picatinny rail and a kit to fit a sling swivel, the senior version is available with many quick change adaptors.
The Junior fits a 9 slot Picatinny rail the senior fits a 13 slot Picatinny rail.
The junior comes with 3 cornered clamping knobs the senior comes with clamping levers that can be pulled out and rotated for angle if pointing the wrong way or just to line up.
The Senior is far more flexible than the junior version but is £100.00 more
Fulcrum Extender Junior KIT £99.00
The Fulcrum Extender Junior kit has been manufactured in response to people wanting a cheaper version of the Fulcrum Extender detailed below.
What you get: You get a kit of parts that can be assembled in around 10 minutes in to the Fulcrum extender Junior consisting of a 50cm Tube (60 cm on request) that can be cut down if needed, a one piece 3cm mount to attach the tube to the bottom of your rifle, a front mount with a 6 slot Picatinny rail ready for a bipod and 2 push in tube caps. You also get a 9 slot Picatinny rail to attach to the bottom of your rifle and 3 levelling wedges to get rid of any slope you may have on the stock of your rifle. The Bipod shown on the picture above showing it attached to a rifle is available below. Harris bipods will require you to use the supplied kit to drill and fit a sling swivel. the sling swivel kit consists of drill guide, drill spanner, sling swivel and ny-lock nut. NOW includes the Picatinny Rail Upgrade kit in addition to the standard clamp on Picatinny rail. This kit allows you to fix a 5 slot Picatinny rail to the main tube using 2 bolts. The kit consists of a drill bit, drill jug, spacer, Picatinny rail, nuts and bolts, spanner and instructions. You will need a cordless drill and some sticky tape to stop the drilling jugs from moving when you drill the mounting holes.
Fulcrum Extender Senior. £199.00
Now supplied with wedge set and Picatinny rail free of charge (worth £15.00)
Fulcrum senior extender Operating instructions are here
Shown with a FireWolf bipod and fitted to a 26" barrelled rifle , Neither are included in this sale.
The Fulcrum Extender is designed to allow you to move your bipod forward to the end of your barrel thus moving the fulcrum. When shooting accurately you want the end of the barrel pointing at the target with as little movement as possible, if you look at a seesaw you will notice the two ends go up and down but the pivot point (fulcrum) stays at the same height and moves very little. With a bipod attached to your rifle in the usual position the stock is at one end of the seesaw with the barrel at the other end, both rotate around the bipod. By moving the bipod to the end of the barrel the rifle is only one end of the seesaw with the end of the barrel at the pivot point. Movement is greatly reduced. The fulcrum extender is made in two lengths so is suitable for any rifle barrel from 12" to 34"+. If you measure from where the Picatinny rail will attach to the rifle to the end of the barrel I can supply a fulcrum extender of the right length.
As the rifle is now supported at the ends only all the weight of the rifle is keeping the rifle stable and reducing felt recoil and muzzle jump. This unit has been successfully tested on 338 Lapua magnum.
Please note the tube clamp must be very tight especially on high recoiling rifles, Failure to keep this clamp tight will result in the tubes sliding apart under recoil and possibly scratching the finish. This is not covered under warranty
Due to the way you attach the bipod to this device you only gain approximately 1/2 inch 12/14mm underneath the rifle so you can use the same bipod as you are already using.
Requires a 13 slot Picatinny rail on the bottom of your rifle for the fulcrum extender to attach too.
Different Bipod adaptors are available depending how your bipod attaches . Please state how your bipod attaches to your rifle so the correct adaptor can be supplied.
One adaptor is supplied as standard although not shown in pictures below.
Additional adaptors are available at £15.00 each.
Operating instructions are here
13 slot Picatinny rail
13 slot Picatinny rail £10.00 (screws or bolts are not supplied)
Attach to the bottom of your stock with bolts or screws if the bottom of your stock is parallel with the barrel
13 slot Picatinny rail plus Levelling wedge Kit
13 slot Picatinny rail plus 3 levelling wedges £15.00 (screws or bolts are not supplied)
If the bottom of your stock is not parallel with the barrel the levelling wedges can be used to correct this.
The levelling wedge kit consists of one 13 slot picatinny rail, one 2.5mm high wedge, one 5mm high wedge and one 10mm high wedge, the wedges can also be combined to make 7.5mm, 12.5mm, 15mm and 17.5mm, Additional wedge packs are available at £5.00 per pack. The wedges are solid plastic (PetG) and could be drilled with additional holes for different rails but are designed to fit the 13 slot picatinny rails supplied by reloading.org.uk. They are 137mm x 16mm x various heights and have 3 x 5mm holes.
Special Offer, Senior Fulcrum Extender KIT £280.00 Just add rifle.
I shoot with one of these at ranges up to 1000 meters or 1KM and found a real difference in accuracy over a standard bipod.
Even at 100 yards there is a noticeable difference. Wish I had one years ago.
The Kit is every thing you need except the rifle and comprises of
A Fulcrum extender
Firewolf long range Bipod.
13 slot Picatinny rail plus 3 levelling wedges to ensure the Picatinny rail is parallel with the barrel. (screws or bolts are not supplied)
Harris Type Bipods
All bipods in this section look like the pictures below.
The Bipod in the picture is shown with an optional adaptor for attaching to a Picatinny/Weaver rail, they do not come with this adaptor but the adaptor is available below if you need one.
Konos 15cm to 22cm Bipod with notched legs (6" to 9" approx)
The Konus 15cm to 22cm bipod is a well made copy of the Harris bipod and uses superior materials that give the bipod extra rigidity over may of the other copies out there. If you look at this bipod and put a Harris alongside it you would be hard pressed to see the difference except in the price. The built-in swivel rotates to either side for instant levelling on uneven ground. The hinge base with tension adjustment and buffer springs. This bipod has notched legs to allow for easy one handed adjustment of the height A branded product for the same money as some shops sell unbranded copies of dubious quality. This Bipod uses the standard sling swivel for attachment to a firearm in the same way a Harris bipod does £45.00
Konos 22cm to 33cm Bipod with notched legs (9" to 13" approx) The Konus 22cm to 33cm bipod is a well made copy of the Harris bipod and uses superior materials that give the bipod extra rigidity over may of the other copies out there. If you look at this bipod and put a harries alongside it you would be hard pressed to see the difference except in the price.The built-in swivel rotates to either side for instant levelling on uneven ground. The hinge base with tension adjustment and buffer springs. This bipod has notched legs to allow for easy one handed adjustment of the height A branded product for the same money as some shops sell unbranded copies of dubious quality. This Bipod uses the standard sling swivel for attachment to a firearm in the same way a Harris bipod does £45.00
Range Right Pro-Tilt 9"-15" Bipod
The AirForce1 Pro-Tilt Bipods are not quite the same quality as the Konus bipod but is good value for the money, they are manufactured with the heat treated steels, and hard alloys. The built-in swivel rotates to either side for instant levelling on uneven ground. The hinge base with tension adjustment and buffer springs. The Bipod attaches to a standard Sling Swivel Stud. This bipod has notched legs to allow for easy one handed adjustment of the height
This Bipod uses the standard sling swivel for attachment to a firearm in the same way a Harris bipod does. £35.00
RangeRight Pro-Tilt 13"-22" Bipod
This bipod looks the same as the bipod pictured above except it has longer legs.The AirForce1 Pro-Tilt Bipods are manufactured with the heat treated steels, and hard alloys. The built-in swivel rotates to either side for instant levelling on uneven ground. The hinge base with tension adjustment and buffer springs. This bipod has notched legs to allow for easy one handed adjustment of the height
This Bipod uses the standard sling swivel for attachment to a firearm in the same way a Harris bipod does. £40.00
Bipod Tightening Handle for Range Right and Konos
The Bipod tightening handle fits in place of the knurled adjustment nut on the above bipods and allows easy adjustment of the swivel head. it is now possible to adjust the rock of the head from very loose to no movement with one hand on the firing point. By pressing the orange button the handle can slide around the central shaft without turning it thus allowing the handle to be moved to the best position for easy adjustment. Only fits bipods with a 5mm male thread such as the ones listed above. £5.00
No fitting charge if purchased at the same time as one of the above bipods
Atlas Type Bipod
This Rifle Bipod fits a Picatinny Rail and is quick detachable via a lever release system.
It is adjustable from 6.5 - 9 inch
Fully adjustable Pan and Tilting Head, Adjustable Leg Lengths: 7.25 - 9 inches, Weight 11.29oz, Attaches to a 1913 Picatinny rail and mounts in seconds
Legs can be placed in one of 5 positions front to back and can be extended through 4 positions
Colour: Black, Material: Aluminium
Legs are spring-loaded and retract with the touch of a button.
The leg extension design allows the shooter to quickly adjust to different heights without having to align each leg equally. £40.00
Firewolf Long range bipod
This long leg Long Range Accuracy Light Tactical Bipod adjusts from 6.6"" to 10"" with a 10° left and right adjustable cant and legs positions including 0°, 22°, 45°, and 90°.
Specifications Weight: 1.4 lbs £80.00
Lightweight Telescopic shooting sticks (Tripod)
HSF Shooting Stick Lightweight versatile telescopic shooting sticks designed to provide a steady rest out in the field. Adjustable between 33" and 75" £30.00
Lightweight Telescopic shooting sticks (Bipod)
HSF Shooting Stick Lightweight versatile telescopic shooting sticks designed to provide a steady rest out in the field. Adjustable between 33" and 75" £25.00
Picatinny rail sling swivel.
This adaptor allows any device that attaches to a standard sling swivel to be attached to a firearm that has a Picatinny/Weaver rail. Commonly use to attach Harris Type Bipods and Slings. £5.00
Uncle Mike's Sling Swivel Stud 3/4" Wood Screw £2.00
Uncle Mike's Sling Swivel Stud 7/8" Machine Screw with Nut £2.00
Second Hand Items:
Harris Adaptor no 4 Clamps on to the barrel of your rifle and provides a sling swivel that allows you to attach a bipod or sling. As new £18.00